Garage Door End Bearing Plate

Garage Door End Bearing Plate

 Features:

  • Offset: 3-3/8”
  • Material: 12 Gauge, Galvanized Steel
  • Type: Residential, Supported with Flange
  • Compatibility: 1” shaft/tube

 About:

The residential supported end bearing plates can be mounted to the punched angle on the horizontal track and with a lag bolt, to the garage header. The measurements of the supported end bearing plate can be determined by the shaft offset; The distance from the garage header to the center of the shaft, which in this case must be 3-3/8 of an inch. The garage door end bearing plates purpose is to support the torsion tube on both ends and to support the lift cable drum. For optimal support, each end bearing plate equipped with built-in 2”x1” garage door steel bearing.

Warning: Carrying out a garage door repair/installation can be dangerous if not preformed according to the local and national standards and verified by a professional.

Submit your review
1
2
3
4
5
Submit
     
Cancel

Create your own review

Average rating:  
 0 reviews